▼

Wednesday, June 26, 2013

It's a crafting miracle!!

My Imagine stopped cutting with CCR after I updated it's firmware a month or so ago. Soooo not happy about that.....

Since then I've bought a new computer that runs Windows 8. I thought for sure I'd have no end of trouble with CCR and Cricut Sync as so many users had reported that they couldn't get either of those to run without running them in Windows 7 compatibility mode.

So imagine my surprise when I installed CCR and Cricut Sync and didn't have to do anything!!! No compatibility problems and no anti-virus problems. I didn't even have to add anything as exceptions to Trend Micro, my anti-virus program! Yay!

Then tonight I thought I'd blow the dust off the Imagine and attempt cutting something. Well, lo and behold it cut!!!! So then I tried a print and cut and that worked too!!!!

Looks like the Imagine has been saved from the deep end of the pool.... again!!! :)


at

2 comments:

Spammers are not welcome here. For that reason I have been forced to turn on Comment Moderation. (I'm seriously tired of deleting spam.)

If you are requesting a file please remember to leave your email address!!

If you don't receive your file within 48 hours please check that I haven't left a reply to your comment!

Some posts have more than one page of comments. Click on "Load More" below the comments. You may need to do that several times to see your post. :)