Sunday, November 17, 2013

CRICUT: Tablescapes Fall & Winter boxes assembly

I had an email last week asking for help on how to put the boxes on the Tablescapes Fall & Winter cartridge together.

So I put a video together showing the steps. Hope it helps.






2 comments:

  1. I think that extra cut on the box is just to help you to layer the leaf on. If you don't want those extra little cuts on your finished project you can remove them in the Craft Room by using the Hide Contour feature.

    ReplyDelete
  2. Hide contour doesn't work on those cuts. They don't show up when you click Hide Contour. They're covered anyway by the leaf... :)

    ReplyDelete

Spammers are not welcome here. For that reason I have been forced to turn on Comment Moderation. (I'm seriously tired of deleting spam.)

If you are requesting a file please remember to leave your email address!!

If you don't receive your file within 48 hours please check that I haven't left a reply to your comment!

Some posts have more than one page of comments. Click on "Load More" below the comments. You may need to do that several times to see your post. :)